2.0 KiB
OpenIPC Wiki
OpenIPC FPV ground station
How to flash the image to your onboard emmc
Wifi
You can setup the onboard wifi for SSH connectivity. (udev rules and networkmanager are already configured in this image, you only need to execute the nmcli commands)
DVR with FPV firmware
DVR functionality; It requires a push button to be installed to the gpio header between physical pins 25 and 27 like so:
To record DVR, push the button once. The stream will start and DVR will begin recording. When finished, push the button once to stop the recording and save the file.
DVR is saved to the Videos folder in your home directory. DVR can be accessed either at /home/orangepi/Videos or via a media server. Connect your groundstation to your home network and it can be accessed via a web browser at x.x.x.x:8080 -- replace x.x.x.x with your groundstation's local ip address.
Connect Led long lead to +5v, Led short lead via a 1k resistor to GPIOAO_2 (The other BLUE pin on Radxa),
sudo gpioset gpiochip4 11=0 #turn LED on
sudo gpioset gpiochip4 11=1 #turn LED off (actually it is very dimly lit because i guess logic level 0 is not 0 volts)
A note about the DVR recording in this image. To ease the strain on the processor, we record to to a ts file rather than mp4 or mkv. As a result, there is no "smear" effect recorded, the uncaptured frames are simply dropped. You may notice jumps in your recording where there was no frame information.
RubyFPV
see RubyFPV Hardware