# OpenIPC Wiki
[Table of Content](../README.md)

OpenIPC AIO "Mario"
-------------------

https://store.openipc.org/OpenIPC-AIO-Mario-v1-0-p633320808

![image](https://github.com/user-attachments/assets/ad675599-61ce-4cec-a9bf-5933d907c53a)

Remove the lens cover film befor use

![image](https://github.com/user-attachments/assets/9ead08a6-f4eb-45a0-bc63-19d3abd3ec1e)



The Mario camera case with 4x M1.2 screws.

Side mount holes are M2 x2 screw thread.

Install atennas for AIO.

![image](https://github.com/user-attachments/assets/e10e6671-553f-4840-aacd-16816be0813b)





**LED function**
Red glimmering	Power on with Battery

Red 	Wired linked

Blue flash	RF transmitter

Green	TBD

Board Size 30mmx32mm with 4*M2 mount holes.

Heat Sink with 20mmx20mm mount holes.

![image](https://github.com/user-attachments/assets/1c7e34c1-76a9-45ee-9caf-ffd33261e154)




**Power Section**

Power input:

2S-6S

The on board dualway BEC Capacity:

RF BEC on board is up to 3A 5V output

MSIC BEC on board is up to 2A 5V output

enter uboot use  uart device connect to top of AIO board(R0,T0)pad.


**connect usb debug port:**

power on AIO with Battery connector(GH1.25* 6 pin), after the blue LED flashing, plug in usb cable and connect to PC

in windows:

go to control panel- internet -network:

find a usb2.0 to fast Ethernet Adapter

set this card ipv4 address to 192.168.1.11 mask:255.255.255.0

apply

then open ssh to connect AIO address:192.168.1.10

user:root password:12345


**RF section**

RF antenna characteristics

![image](https://github.com/user-attachments/assets/d54050b4-2769-4942-95d7-8aad3b5e2e21)

![image](https://github.com/user-attachments/assets/0a709f70-ac8b-4880-93f5-49e1d958eb1b)


Default Antenna is ANT1 for 1T1R, ANT0+ANT1 is 2T2R

Reconmand RF setting 
  
  RF Power max 18dbm for onbard PA. 0~-25dbm setting
  
  MCS index 1,3(0-7 is 1T1R, 8+ is 2T2R)
  
  stbc=1,ldpc=1
  
  Video biterate:4096 /8192/12688(mcs 3+)

  Keep RF poweroff or power=1 when on bench test(when only usb connect)
  
**SD solt for Air camera record**

on bench test or debug is disable the record function defaultly

To enable the recording function set (record value)true in majestic.yaml



On board heat sink and cooling fan:

cooling fan out put power up to 500mA max

all heat sink mount holes are M2 screws thread.




**Extend connector**

![image](https://github.com/user-attachments/assets/af8124e3-539f-42c6-a757-a560eb93e3fe)

**Todo**

USB only for debug mode

Power limited 5W input.