diff --git a/en/install-lifesmart.md b/en/install-lifesmart.md
new file mode 100644
index 0000000..66629be
--- /dev/null
+++ b/en/install-lifesmart.md
@@ -0,0 +1,46 @@
+# OpenIPC Wiki
+[Table of Content](../README.md)
+
+For LifeSmart cameras: LS179
+
+## BOM
+
+SoC: HI3518EV200  
+Flash: ENQH127A (16MB NOR)  
+Sensor: soif23 (???)
+
+## Installation
+
+Follow the [instructions](help-uboot.md#bypassing-password-protected-bootloader) to get access to U-boot.
+
+Back up the flash and install OpenIPC according to the [instructions](https://openipc.org/cameras/vendors/hisilicon/socs/hi3518ev200).
+
+Select a 16MB NOR flash, and use the Ultimate firmware if you want to use WiFi.
+
+## WiFi
+
+In order to connect to WiFi, you need to configure the [wireless device](wireless-settings.md#initial-configuration) with `rtl8188fu-hi3518ev200-lifesmart`
+
+```
+fw_setenv wlandev rtl8188fu-hi3518ev200-lifesmart
+# also configure your WiFi
+fw_setenv wlanssid "MySSID"
+fw_setenv wlanpass "password"
+# and then...
+reboot
+```
+
+This will power up the USB WiFi module (GPO #54), and load the appropriate Kernel driver (`8188fu`).
+
+## LEDs
+
+The LEDs are controlled by the GPO #2.
+
+```bash
+# turn on
+gpio set 2
+
+# turn off
+gpio clear 2
+```
+